Atomstack  laser engraving machine is a high-precision cutting tool, please pay attention to the following precautions before use to ensure your personal safety and the normal operation of the equipment.

Inspection Before Starting Up

1. Check whether the environment where the  Atomstack S20 Pro  laser engraving machine is located meets the requirements. It needs to be spacious, dry and well ventilated.

2. Check whether the power cord is tight and not damaged, and whether the plug is in stable contact.

3. Check whether the water path of the water cooler is unblocked and whether the water level is normal.

4. Check whether the laser is normal, such as the indicator light is on, etc.

5. Check whether there are foreign objects in the pull rod, guide rail, slider and other parts, clean the laser lens, and ensure the sanitation of the equipment.

boot operation

1. Press the power switch of the main engine, wait for one minute after the beep of the laser disappears, until the water flow is normal and the optical path is stable, etc. all reach the normal state.

2. Turn on the cold water pump, turn on the water cooler, and ensure that the water temperature is operating normally.

3. Start the computer and follow the prompts of the laser engraving software to set up.

4. Adjust the cutting table downward to ensure that the distance between the cutting table and the laser is appropriate.

Precautions For Use

1. Avoid operating personnel in the range of laser radiation for a long time, so as not to cause harm to the body.

2. During the operation, do not modify the parameters of the Atomstack S30 Pro laser engraving machine without permission, so as not to affect the performance of the equipment.

3. Do not switch the machine too frequently during operation, so as not to affect the life of the equipment.

4. When cutting, pay attention to cutting against the surface of the platform, and at the same time ensure that the surface of the cutting platform is clean, and do not place too large or heavy items on the surface, so as not to affect the accuracy.

5. When using equipment such as laser, ultraviolet and infrared rays, please do not face the laser aperture directly to avoid eye damage.

6. During the operation, if any abnormal situation occurs, be sure to stop the machine in time, check the cause and repair it in time.

Shutdown Operation

1. Close the computer software.

2. Turn off the cooler and cooling water pump, and turn off the laser.

3. Turn off the main power and unplug the power plug.

4. If not in use for a long time, please turn off the power of the laser and clean the surface of the device.

In short, the opening and closing process of the  laser engraver  is very important, and it must be operated in strict accordance with the regulations to ensure the normal use of the equipment and the safety of the operator. At the same time, before using the tool, you must carefully read the instruction manual to understand the nature, content and precautions of the machine. Reasonable use and maintenance of the equipment is also the key to its stable and efficient operation.